TM 5-3610-286-20
2-78.
Lubrication Distribution System (cont).
(7) Oil, that is not diverted to the feeder end of the press by the tee fitting above the pump,
(8)
continues upward on the D/S of the press. The two lubrication oil lines on top of the pump
supply oil to three separate distribution units. The vertical oil line originating at the tee
fitting supplies a manifold (figure 2-217) that feeds nine oil lines that direct oil to Iubrica-
tion points on the D/S of the press.
The second output line from the oil pump supplies oil to two distribution units that are inter-
connected through a hollow bolt. The lower distribution unit has three outputs on the ex-
terior D/S of the press. The topmost distribution unit is supplied with oil through a copper
oil line. This oil, in turn, is fed through the side of the press to internal lubrication points
through five nylon oil lines.
2-438
