TM 5-3610-286-20
2-67.
Ranger Drum Shaft Assembly (cont).
(c) Sheet segment guides. (figure 2-157)
NOTE
Sheet segment guides are numbered 1 through 9, starting at O/S. Replace
each guide in the same position as removed.
Rotate assembly to access hardware and remove socket-head screw (1) and washer
(2) from segments 1,3,5,7, and 9 (3).
Push laterally on segments and remove segments 1,3,5,7, and 9 (3).
CAUTION
Segments 2, 4, 6, and 8 are under pressure from compressed springs.
Rotate assembly until gripper bar is positioned so that compression springs (4) are up
and horizontal.
Loosen two hex-head screws (5) on spring rod guides (6) between sheet segments 2
and 4 (7).
Loosen socket-head screws (1) for sheet segments 2 and 4 (7).
Carefully compress springs (4) off of sleeve guides (8) and remove springs (4).
Remove two hex-head screws (5), Iockwashers (9), washers (10), and spring rod
guides (6).
Remove socket-head screw (1) and washers (2) from segments 2 and 4, and remove
segments (7).
Repeat steps 4 through 8 for sheet segments 6 and 8.
Replace damaged sheet segments.
2-348
