TM 5-3610-286-20
Suction Slowdown Assembly.
2-58.
This task covers:
a. Remove
b. Repair
c. Install
INITIAL SETUP
Tools
Equipment Conditions
5 mm hex key
Delivery guard open (TM 5-3610-286-10)
6 mm hex key
Delivery light removed (para. 2-54)
8 mm combination wrench
10 mm combination wrench
Additional Personnel Requirement
13 mm combination wrench
17 mm combination wrench
Printing and Binding Specialist MOS 83F20
Ball-peen hammer
4 mm pin punch
1.0 x 6.0 x 0.5 mm flat-tip screwdriver
0.050 x 0.375 x 8 in. flat-tip screwdriver
a. Remove. (figure 2-130)
(1) Slide suction slowdown assembly (1) out as far as it will go.
(2) Loosen hose clamp (2) and remove hose (3).
(3) Remove two slotted screws (4) and drop limit switch (5), but do not disconnect
electrically.
(4) Remove four screws (6) and drop suction motor (7) but do not disconnect electrically.
(5) Remove four screws (8), four nuts (9), two springs (10), and remove sheet stop (11).
(6) Remove two socket-head stop screws (12) from guide rails (13).
WARNING
Assembly exceeds 35 pounds. Use two persons to remove.
(7) Remove suction slowdown assembly (1).
2-296
