TM 5-3610-286-20
2-43.
Swing Gears.
This task covers:
a. Remove
b. Repair
c. Install
INITIAL SETUP
Tools
Equipment Conditions
6 mm hex key
Main guard (D/S) removed (para. 2-20)
10 mm hex key
Lubrication distribution line removed (para. 2-78)
10 mm combination wrench
Printing press “O” position (TM 5-3610-286-10)
19 mm combination wrench
4 mm pin punch
Ball-peen hammer
a. Remove. (figure 2-89)
(1)
(2)
(3)
(4)
2-220
NOTE
Block plate cylinder so that it does not rotate when swing gear is removed.
Remove socket-head screw (1), washer (2) and pointer (3).
Remove four hex nuts (4), washers (5), hex spacer nuts
and spacer washers (8).
Remove gear (9).
Remove six socket-head cap screws (10), washers (11),
(6), cup spring washers (7),
pin (12), and flange gear (13).
