TM 5-3610-286-20
2-36. Engaging Lever Assembly (cont).
d. Adjust. (figure 2-74)
(1)
(2)
(3)
(4)
(5)
(6)
Using manual lever, put press in Impression OFF.
Check that roller of engaging lever latch (1) is resting evenly in the left (feeder end) notch
of the engaging lever (2). Check that roller is not held too tightly in notch or too loosely
(look for uneven spacing around the roller).
Adjust latch roller fit by loosening lock nut (3) on engaging lever (2) and rotating rod (4)
left or right to lower or raise position of engaging lever as required.
Tighten lock nut (3) when proper roller position is attained,
Using manual lever, put press in Impression ON.
Repeat steps (2) through (4) for adjustment of roller in the right (delivery end) notch of the
engaging lever (2).
2-190
