TM 5-3610-286-20
2-30.
Vibrator Roller Bearing Assembly (cont).
b. Repair. (figure 2-53)
NOTE
Disassembly of both bearing assemblies is the same.
(1)
(2)
(3)
(4)
(5)
(6)
(7)
(8)
(9)
(10)
(11)
2-152
Remove set screw (1), adjusting screw (2), lock nut (3), washer (4), and spring (5)
from bearing asembly (6).
Remove, spring pin (7), pin (8), and latch (9) from lever (10).
Remove hexhead screw (11) and lock nut (12) from latch (9).
Remove pin (13), roller bearing (14), and grease fittings (15) from levers (10)
and (16).
Remove tapered pin (17) and lever (18) from shaft (19).
Replace broken, cracked, distorted, and excessively worn parts.
Aline lever (18) on operator end of shaft (19), and replace tapered pin (17).
Replace and aline roller bearing (14) in levers (10) and (16), and replace pins (13).
Replace hex screw (11) and lock nut (12) on latch (9).
Replace pin (8) through latch (9), into lever (10). Replace spring pin (7) in lever (10).
Replace spring (5), washer (4), adjusting screw (2), lock nut (3), and set screw (1) in
bearing assembly (6).
