TM 5-3610-286-20
2-24.
Ink Fountain Assembly (cont).
(n) Remove grease fitting (Sheet 3, 24) on ink fountain roller clutch (25).
(o)
(p)
(q)
(r)
(s)
(t)
(u)
(v)
Remove flexible line lubrication fitting (26) from D/S lubrication distribution unit (27).
Remove D/S lubrication fitting (28) from end cap (29).
Remove three hex screws (30), washers (31), and snap ring (32).
Support ink fountain roller with wooden blocks.
Slide off end cap (29) with needle bearing (33) and spacer (34) from ink fountain roller
(7) shaft end D/S.
Slide off circular shims (35) and spacer (36).
NOTE
Shims are used to eliminate end play of ink fountain roller. Count number of
shims since amount of shims used will vary between TSS presses.
Remove snap ring (37) and slide off washer (38), ink fountain roller clutch assembly
(25), and washer (39).
WARNING
Ink fountain roller exceeds 35 pounds and requires two persons for removal.
Depress ductor roller stop lever (O/S) (Sheet 2, 40) out of way and slide ink fountain
roller (Sheet 3, 7) out of press through hole in D/S side frame.
NOTE
Needle bearing in O/S side plate will remain in place.
(w) Remove inner bushing (41) and outer bushing (42).
NOTE
Inner bushing is wider than outer bushing.
(x) Remove needle bearing (43).
2-108
