TM 5-3610-285-14
b.
Remove cover plate on underside of vacuum control box.
c.
Remove two screws securing vacuum control box to vacuum frame.
d.
Remove vacuum frame vacuum hose from control box. Set control box aside.
e.
Remove top drawers from 10-drawer photolithographic cabinet.
f.
Remove hex nuts and lockwashers securing vacuum frame shock mounts to each corner of photolithographic
cabinet.
g.
Lift defective contact vacuum frame from photolithographic cabinet, and remove from van.
h.
Install new contact vacuum frame.'
i.
Reinstall hex nuts and lockwashers to secure vacuum frame to photolithographic cabinet.
j.
Reattach vacuum frame vacuum hose to control box, and secure control box to frame with two screws.
k.
Reinstall cover plate on underside of vacuum control box.
l.
Reinstall drawers in photolithographic cabinet.
m.
Plug in power cord.
6-17.
PREPARATION FOR STORAGE OR SHIPMENT . Contact your battalion for packing and shipping instructions.
Section V. DIRECT/GENERAL SUPPORT MAINTENANCE
There are no direct/general support maintenance procedures assigned for this equipment.
6-57
