TM 5-3610-285-14
CONTROL.OR INDICATOR
FUNCTION
MAIN DRIVE Switch
Activates main drive motor and
machine logic.
LAMPS Switch
Activates the lights behind the
flowmeter and developer temperature pilot light.
DEV TEMP Indicator Light
Indicates when power is applied to
the developer heater. Indicator
light will slowly flash on and off
when the developer reaches
operating temperature.
Drain Valves
Used to drain their three
respective processor tanks.
TRANSPORT SPEED Control Knob
Used to select desired transport
speed. Increases if rotated right,
and decreases if rotated left.
TRANSPORT SPEED METER
Indicates speed of film transport
in centimeters per minute (cm/min).
Purge Valves
Purge air from replenishment
system.
REPL PUMP Switch
A three-position switch. In AUTO
position, the detector roller
switches will turn on replenisher
pumps, start the feed signal timer,
and activate accessory outlet when
material is fed between detector
rollers. In OFF position,
replenisher system is turned off.
In MANUAL position, detector
switches are bypassed and
replenisher pumps are turned on.
REPL PUMP Indicator Light
Indicates when replenisher pumps
are activated.
STANDBY RESET Switch
This switch changes processor from
STANDBY to OPERATING MODE. The
processor is adjusted to
automatically change to standby
mode after last piece of material
clears dryer.
5-20
