TM 5-3610-285-14
2-20.
MAINTENANCE PROCEDURES.
a.
This section contains instructions covering direct/general support maintenance functions for the flip-top
platemaker. Personnel required are listed only if the task requires more than one.
b.
After completing each maintenance procedure, perform operational check to be sure that equipment is properly
functioning.
INDEX
PROCEDURE
PARAGRAPH
Replace Integrator Circuit Board (ICB) . .................................................................................................
2-20.1
Replace Control Circuit Board (CCB) .....................................................................................................
2-20.2
Replace Digital Display Board (DD)........................................................................................................
2-20.3
Replace Keypad (KP).............................................................................................................................
2-20.4
Replace 3kW Power Supply Circuit Board (PSI) ....................................................................................
2-20.5
Replace Strike Transformer (ST-1 or 2)..................................................................................................
2-20.6
Replace Strike Transformer Overtemperature Switch (THS1 or 2) . .......................................................
2-20.7
2-103
