TM 5-3610-257-14
8-13.
SERVICE UPON RECEIPT.
8-13.1. Checking Unpacked Equipment.
a.
Inspect the equipment for damage incurred during shipment. If equipment has been damaged, report the
damage on DD Form 6, Packing Improvement Report.
b.
Check the equipment against the packing list to see if the shipment is complete. Report all discrepancies in
accordance with the instructions of DA Pam 738-750.
c.
Check to see whether the equipment has been modified.
8-14.
ORGANIZATIONAL PREVENTIVE MAINTENANCE CHECKS AND SERVICES. There are no organizational
PMCS procedures assigned for this equipment.
8-15.
ORGANIZATIONAL TROUBLESHOOTING PROCEDURES.
a.
Organizational troubleshooting procedures cover the most common malfunctions that may be repaired at the
organizational level. Repair or adjustment requiring specialized equipment is not authorized unless such equipment is
available. Troubleshooting procedures used by the operator should be conducted in addition to the organizational
troubleshooting procedures.
b.
This manual cannot list all the possible malfunctions or every possible test/ inspection and corrective action.
If a malfunction is not listed or is not corrected by a listed corrective action, notify your supervisor.
c.
If the viewing stand does not power up when turned on, verify that 120 V ac is present at the receptacle. If
voltage is not present, plug equipment into receptacle with power available and proceed with equipment troubleshooting.
Perform no-power troubleshooting procedures for dead receptacle (Table 1-4).
Table 8-3. ORGANIZATIONAL TROUBLESHOOTING
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
1.
NO ILLUMINATION WITH LIGHT SWITCH IN ANY POSITION.
Step 1.
Check that circuit breaker is on.
(a)
If circuit breaker is on, proceed to step 2.
(b)
Reset circuit breaker.
8-10
