TM 5-3610-257-14
Section V. DIRECT/GENERAL SUPPORT MAINTENANCE
3-18.
REPAIR PARTS, SPECIAL TOOLS; TEST, MEASUREMENT, AND DIAGNOSTIC EQUIPMENT (TMDE); AND
SUPPORT EQUIPMENT.
3-18.1
Common Tools and Equipment. For authorized common tools and equipment, refer to the Modified Table of
Organization and Equipment (MTOE) applicable to your unit.
3-18.2
Special Tools; Test, Measurement, and Diagnostic Equipment; and Support Equipment . Special Tools,
TMDE, and Support Equipment is listed in the applicable repair parts and special tools list and in Appendix B of this
manual.
3-18.3
Repair Parts. Repair parts are listed and illustrated in the Repair Parts and Special Tools List, TM 5-3610-257-
24P covering direct/general support maintenance for this equipment.
3-19.
DIRECT/GENERAL SUPPORT TROUBLESHOOTING PROCEDURES.
a.
Direct/general support troubleshooting procedures cover the most common malfunctions that may be repaired at
the direct/general support level. Repair or adjustment requiring specialized equipment is not authorized unless such
equipment is available. Troubleshooting procedures used by lower level maintenance should be conducted in addition to
the direct/general support troubleshooting procedures.
b.
This manual cannot list all the possible malfunctions or every possible test/inspection and corrective action. If a
malfunction is not listed or corrected by a listed corrective action, notify your supervisor.
c.
For unidentified malfunctions, use the foldout located at the end of this manual for further fault analysis.
Table 3-6. DIRECT/GENERAL SUPPORT TROUBLESHOOTING
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
1.
CAMERA LAMPS WILL NOT TURN ON.
Check for defective lamps receptacle.
Replace receptacle (TM 5-3610-258-14).
2.
CAMERA LIGHTS WILL NOT TURN OFF.
Check for defective lamp relay.
Refer to Lithographic Copying Camera maintenance instructions (TM
5-3610-258-14).
3-55
