TM 5-3610-257-14
NOTE
• PILOTS switch in PILOTS position allows lighting of red lamps on remote control unit.
(1)
Remove jumper plug from REMOTE socket.
(2)
Insert remote control unit cord into REMOTE socket.
(3)
Position ON switch on exposure control instrument to ON.
(4)
Control operations from remote control unit.
q.
Shutdown procedures.
(1)
Set FOCUS switch to off position.
(2)
Return all time units to 000.
(3)
Set left DENSITY dial to 1.0 and right DENSITY dial to .00.
(4)
Set ON switch to off position.
3-7.
OPERATION UNDER UNUSUAL CONDITIONS. This equipment is designed for operation only in a controlled
environment.
Section III. OPERATOR MAINTENANCE
3-8.
LUBRICATION INSTRUCTIONS. This equipment does not require lubrication.
3-9.
TROUBLESHOOTING PROCEDURES.
a.
The table lists the common malfunctions which you may find during operation or maintenance of the light
integrating exposure control instrument, or its components. You should perform the test/inspections and corrective actions
in the order listed.
b.
This manual cannot list all malfunctions that may occur, nor all test or inspections and corrective actions. If
a malfunction is not listed or is not corrected by listed corrective actions, notify your supervisor.
3-49
