TM 5-3610-252-14
1-10.3 Replace Blackout/Dome Light.
MOS:
83F, Photolithographer
TOOLS: None
SUPPLIES:
Lamp (12 V)
Silicone Spray (Item 18, Appendix E)
NOTE
Blackout light and dome light are sealed units. No bulb replacement is
possible.
Complete light must be replaced.
a.
Push light and gasket up into opening.
b. Tilt and remove light and gasket from opening.
c.
Disconnect defective light from connector.
d. Connect new light to connector.
e.
Reinstall gasket in opening.
NOTE
The use of silicone spray on the gasket will help to position light.
f.
Position light in gasket and push in.
1-48
