TM 5-361O-252-14
k. Remove hydraulic ram (paragraph 2-16.6).
1.
Remove piston sleeve (paragraph 2-16.5).
m.
Remove control valve (paragraph 2-16.3).
n.
Remove reservoir (paragraph 2-16.2).
o.
Inspect components for damage or wear and replace defective components
as necessary.
p.
Install reservoir, control valve, piston sleeve, hydraulic ram, and
overload valve on new hydraulic housing.
q.
Slide axle with one wheel attached back into hydraulic unit stem.
Secure by driving in split pin.
Then reinstall remaining wheel and
secure with split pin.
r.
Reinstall hydraulic unit assembly on truck.
s.
Reinstall ram of hydraulic unit to frame and secure by driving in split
pin.
t.
Reinstall traverse on hydraulic unit and secure with bolts and washers.
Reinstall snap ring.
WARNING
Serious injury may result if an inadequate number of personnel are used
to turn hydraulic pallet truck upside down. This equipment weighs
197 lbs.
u.
Carefully turn truck back onto wheels (two persons required).
v.
Reinstall handle and secure with retaining bolts.
w.
Attach chain connector to activator arm.
x.
Wipe hydraulic unit, handle components, and wheel components free of
fluid and dirt.
y.
Fill with hydraulic fluid and bleed air from system.
2-35
