TM 5-2330-305-14
Section III. MAINTENANCE INSTRUCTIONS
5.3.1 MAINTENANCE procedures This section contains the step-by-step procedures
for performing Direct/General Support Maintenance for the Chassis, Semitrailer.
Personnel required are listed only if the task requires more than one. If personnel
are not listed, it means one person can do the task.
.
5.3.2 GENERAL There are no procedures for the removal and installation of the
major components and assemblies which are the responsibility of Direct/General Sup-
port maintenance.
All major components or assemblies require disassembly during
repair and are not included in this section.
INDEX
Procedures
PARAGRAPH
Repair Landing Gear Assembly . . . . . . . . . . . . . . . . . . . . . .5.3.2.1
Replace Cam Bearing . . . . . . . . . . . . . . . . . . . . . . . . ..5.3.2.2
Replace Brakes . . . . . . . . . . . . . . . . . . . . . . . . . . . . .5.3.2.3
Repair Leveling Jack. . . . . . . . . . . . . . . . . . . . .5.3.2.4
Replace
Replace
Replace
Bearing/Seal s . . . . . . . . . . . . . . . . . . . . . . . ...5.3.2.5
Hub/Drum Assembly . . . . . . . . . . . . . . . . . . . . . ...5.3.2.6
Air Tank . . . . . . . . . . . . . . . . . . . . . . . . . . ..5.3.2.7
5.3.2.1 REPAIR LANDING GEAR ASSEMBLY.
TOOLS: Tool Kit
SUPPLIES: Cleaning Solvent
Gear Grease
BE SURE CHASSIS
AND IS UNHOOKED
CAUTION
IS PARKED ON LEVEL GROUND
FROM TRUCK BEFORE PROCEED-
ING TO PREVENT PERSONNEL INJURY.
1. Remove landing gear assembly from chassis. (4.4.1.10)
2. Remove nut and bolt which secure handle to gearbox shaft. Remove
hand1e.
3. Remove six nuts and six bolts which secure gearbox cover. Remove
gearbox
. cover.
4. Remove two gearbox shaft bearings.
5-2
