KEY
INTERVALS
EXPECTED TEMPERATURES
MONTHLY
OGP
M
CARGO DOOR
LUBRICATING OIL,
(MIL-L-7870)
GENERAL
PURPOSE,
HINGES
Q
QUARTERLY
LOW TEMPERATURE
PERSONNEL
W
WEEKLY
DOOR LATCHES
s
S E M I
CARGO DOOR
ANNUALLY
LATCHES
All Temperatures
RETRACTABLE
STEP HINGE
FAN COVER
AIR VENT
HINGE
PAPER DRILL
MOTOR SLIDES
PAPER DRILL
TREADLE HINGE
PAPER STITCHER
HEAD
PERSONNEL
DOOR HINGES
GAA
GREASE ,
PAPER CUTTER
MI L-G-10924) AUTOMOTIVE
GREASE FITTINGS
AND ARTILLERY
OHT
HYDRAULIC FLUID,
PAPER CUTTER
HYDRAULIC
MI L-H-6083) PETROLEUM BASE.
RESERVOIR
LUBRICATING
PAPER CUTTER
GO-90
OIL, GEAR,
GEAR BOX
MI L-L-2105}
MULTIPURPOSE
PAPER CUTTER
BACKGAUGE
9. Change gear box oil monthly. Remove fill plug at top of gear
NOTES
box. Remove drain plug, located below sight glass, and drain oil.
Reinstall drain plug. Add GO-90 (MlL-L-2105) Iubricating oil until
Before lubricating, wipe all points free of dirt, grease or dust.
oil shows in the sight glass. Reinstall fill plug.
Wipe all surplus 011 from surfaces after lubrication.
10. OIL CAN POINTS, In accordance with the intervals listed in
this Lubrication Order, lubricate the Door Hinges and Latches, Step
When lubricating hinges, be sure oil covers entire length of hinge.
Hinges, Air Vent Hinge and Exhaust Fan Cover Hinge with OGP.
Apply two grease gun strokes to each grease fitting.
Wipe all excess grease from fittings after lubricating,
Copy of this Lubrication Order will remain with the equipment at
all times; instructions contained herein are mandatory.
Check for presence of hydraulic fluid insight glass. lf hy-
By Order of the Secretary of the Army
draulic fluid is not present insight glass add fluid. To add hy-
draulic fluid, remove main drive belt guard. Remove inspection
cover and carefully remove gasket, Add OHT (MIL-H-6083) hy-
JOHN A. WICKHAM, JR.
draulic fluid to reservoir until level is visible insight glass, Rein-
General, United State Army
stall belt guard.
Chief of Staff
Official:
Be sure lubricating screw cartridge is full of GO-90 (M IL-L-
05) lubricating oil, Move backgauge to its rear limit of travel,
ROBERT M. JOYCE
bile an assistant moves the backgauge forward, twist the handle
Major General, United States Army
the lubricating screw three turns,
The Adjutant General
Check the gear box sight glass for the presence of oil, If oil
does not show in the sight glass, add GO-90 (MIL-L-2105) lub-
ricating oil through the fill port located at the top of the gear
DISTRIBUTION:
box, until oil shows in the sight glass.
To be distributed in accordance with DA Form 12-25A,
Operator maintenance requirements for Mapping.
05-3610-253-12
* US
CARD 5 0F 5
GOVERNMENT
PRINTING
OFFICE
1983666-742
