TM 5-6675-324-14
Rotate developing cylinder shaft so that flat on the shaft is
ae.
alined with the position of the setscrew on plate M. Install plate
M and tighten setscrew.
af.
Reinstall securing screw and bias cable.
ag.
Reinstall blade and dust guard and secure with screws.
ah.
Reinstall interior lid and hopper.
NOTE
Portion of side plate at front of developing assembly should be engaged in
q
groove in part of developing assembly support.
Prevent hopper lid from touching platen.
q
Refill hopper with two bags of new developer. Turn drive gear manually
ai.
to the right to coat cylinder with new developer.
aj.
Slowly lower developing assembly onto its support while pushing toward
rear side plate.
ak.
Reconnect plugs.
al.
Lower holddown clamps.
Reinstall top right panel.
am.
Return platen to home position.
an.
ao.
Plug in power cord.
3-204