TM 5-6675-324-14
NOTE
To increase leading edge, move RS3 to right as viewed from rear of copier.
To decrease leading edge, move RS3 to left.
Loosen reed switch RS3 mounting screw. Adjust position of RS3 so that
q.
the leading edge of the image is 3 - 8 mm (0.12 in. to 0.31 in.) from
leading edge of copy. Tighten screw.
r.
Repeat steps n thru p until proper adjustment is obtained.
Turn power switch to O (OFF).
s.
t.
Remove jumper wire from J402-1 and J405-1 and reconnect connectors.
Reinstall upper rear panel and remove NA test sheet from platen.
u.
3-20.32 Adjust Platen Drive Wire.
MOS:
35E, Special Electronic Devices Repairer
TOOLS:
No. 2 Cross Tip Screwdriver
Spring Hook
SUPPLIES: Spring
WARNING
Death or serious injury may occur from electrical shock unless power cord
is unplugged before servicing.
a.
Turn power switch to O (OFF).
b. Unplug power cord.
c.
Remove upper rear panel.
3-208