TM 5-6675-324-14
Loosen mounting screws on blade mounting plate.
0.
Put the 0.2 mm and 0.04 mm gages together to make a 0.24 mm gage.
p.
Insert the feeler gage between the blade and cylinder on one side, and
q.
snug up that mounting screw while holding the blade against the gage.
Repeat for the other side and snug up that mounting screw.
r.
s.
Recheck clearance and readjust as necessary.
Reinstall dust guard and tighten all screws.
t.
NOTE
P o r t i o n of side plate at front of developing assembly should be engaged in
groove in part of developing assembly support.
u.
Slowly lower developing assembly onto its support while pushing rear
side plate.
Reconnect connectors.
v*
w.
Reinstall top right panel.
Refill hopper with new developer in accordance with operating
x.
Return platen to home position.
y.
Plug in power cord.
z.
3-198