TM 5-6675-316-14
e. Compare figure resulting from tape run to figure above to be sure they are identical.
f. Use magnifying glass to inspect line quality of test figure. Check that lines touch at correct spot and do not
overlap or run over. In the event the lines are not satisfactory, correct as follows:
(1) Check that bearings of both X and Y carriages have been properly reset (paragraph 3-6.1).
(2) Check that X and Y carriages are properly and fully engaged.
(3) Check that tensioning device is properly installed (paragraph 3-6.1).
3-56
Change 1