TM 5-6675-316-14
Section IV ORGANIZATIONAL MAINTENANCE
8-11.
8-12.
MENT
tional
LUBRICATION PROCEDURES.
This equipment does not require lubrication.
REPAIR PARTS, SPECIAL TOOLS; TEST, MEASUREMENT,
(TMDE); AND SUPPORT EQUIPMENT.
These items are
level of maintenance.
AND DIAGNOSTIC EQUIP-
not used at the organiza-
8-13. SERVICE UPON RECEIPT.
8-13.1
Ch ecking Unpacked Equipment.
Inspect the equipment for damage incurred during shipment. If the equipment
has been damaged, report the damage on DD Form 6, Packing Improvement Report.
b. Check the equipment against the packing list to see if the shipment is
complete.
Report all discrepancies in accordance with DA Pam 738-750.
c.
Check to see if the equipment has been modified.
8-14. ORGANIZATIONAL PREVENTIVE MAINTENANCE CHECKS AND SERVICES. There are
no organizational PMCS procedures assigned for this equipment.
8-15. ORGANIZATIONAL TROUBLESHOOTING PROCEDURES.
If the adhesive wax coater
does not power up when turned on, verify that 120 V ac is present at the receptacle.
If voltage is not present, plug equipment into receptacle with power available and
proceed with equipment troubleshooting.
Perform no-power procedures for dead
receptacle (Table 1-4).
If power is present replace the adhesive wax coater.
8-16. MAINTENANCE PROCEDURES. There are no organizational maintenance procedures
assigned for this equipment.
8-17. PREPARATION FOR STORAGE OR SHIPMENT. Contact your battalion for packing
and shipping instructions.
8-36
