TM 5-3610-253-14
Remove mounting bolts on switch mounting plate.
c.
Cut wire ties as necessary to move switch out enough to have easy access
d.
to wiring.
e.
Loosen captive screw on switch cover and lower cover.
Tag and disconnect wiring.
f.
Remove switch mounting screws and defective switch.
g.
Install new switch and secure with mounting screws.
h.
Reconnect wires and close switch cover and secure with screw.
i.
Reinstall switch mounting plate to frame and secure with bolts.
j.
Install new wire ties.
k.
Place operator key back into safety lock.
l.
m.
Reinstall rear electronics enclosure cover.
n.
5-40.42 Replace Clamp Proximity Switch.
MOS: 35E, Special Electronic Devices Repairer
Flat Tip Screwdriver
TOOLS:
10 mm Combination Wrench
24 mm Combination Wrench
No. 2 Cross Tip Screwdriver
10 mm Socket with 3/8 in. Drive
Wire Cutters
12 in. Adjustable Wrench
Proximity Switch (b29)
SUPPLIES:
Wire Ties
WARNING
Death or serious injury may occur from electrical shock unless power is
is turned off before servicing.
Turn off power.
a.
(1) Turn Star-Delta switch to Y position, then to O position.
(2) Turn main power switch to O position.
5-589