TM 5-6675-325-14
Section III OPERATOR MAINTENANCE
9-8. LUBRICATION INSTRUCTIONS. This equipment does not require lubrication.
9-9. TROUBLESHOOTING PROCEDURES.
a. The table lists the common malfunctions which you may find during the
operation or maintenance of the magnifier lamp, or its components.
YOU should
perform the test/inspections and corrective actions in the order listed.
b. This manual cannot list all malfunctions that may occur, nor all test or
inspections and corrective actions.
If a malfunction is not listed or is not
corrected by listed corrective actions, notify your supervisor.
Table 9-2. TROUBLESHOOTING
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
1.
FLUORESCENT LAMP WILL NOT WORK.
Be sure that magnifier lamp assembly is plugged into active power outlet.
Press switch OFF, then ON.
(a) If lamp still does not come on, replace 1 amp (paragraph
9-10.1).
(b) If new lamp does not light, refer to organizational
maintenance.
9-10. MAINTENANCE PROCEDURES.
This section contains instructions covering operator maintenance functions
for the support items.
Personnel are listed only if the task requires more than
one.
a .
b. After completing each maintenance procedure, perform operational check to be
sure that equipment is properly functioning.
PROCEDURE
INDEX
PARAGRAPH
Replace Lamp in Magnifier Lamp Assembly . . . . . . . . . . . . . . . . 9-10.1
9-11
