TM 5-6675-325-14
b. Remove screws and washers holding stainless steel tank and casing
to chassis.
c.
Lift stainless steel tank and casing free. Set aside.
NOTE
Do not disconnect wires to transducer.
d. Tag and disconnect power cord wire from power switch.
e.
Press sides of defective power switch and remove from chassis.
f. Install new power switch in chassis.
Push power switch until tabs lock
into hole.
g.
Reconnect power cord wires to power switch.
h. Reinstall stainless steel tank and casing. Secure with screws and
washers.
i.
Fill stainless steel tank 1/3 full with water.
j.
Plug in power cord and turn power on. Check that water surface
agitates.
6-15
