TM 5-6675-325-14
Table 5-5. TROUBLESHOOTING - Cont
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
14. CALCULATOR PRINTER WILL NOT ADVANCE - Cont
Step 4.
Check to see if calculator PRGM/RUN switch is set to RUN.
(a) If PRGM/RUN is set properly, proceed to step 5.
(b) Set switch to RUN.
Step 5.
Run calculator diagnostic program on preprogrammed magnetic card.
Replace calculator.
15.
CALCULATOR PRINTER ADVANCES, BUT NOTHING PRINTS WHEN
Step 1.
Check to see if paper roll is jammed.
(a) If paper roll is free, proceed to step 2.
(b) Free paper roll.
Step 2.
Perform checks in malfunction 14.
16. AUTO-SCALER LED DISPLAY DOES NOT OPERATE OR SHOWS INCORRECT COUNT.
step 1.
Check to see if power source has 10 v dc to 15 V dc output.
(a) If output is correct, proceed to step 2.
(b) Change power source.
Step 2.
Check to see if voltage on regulator on main logic PC board is 8 V
dc .
(a) If voltage is correct, proceed to step 3.
(b) Notify direct support maintenance for replacement of main
logic PC board.
5-133
