TM 5-6675-325-14
b. Remove screws holding air duct to air conditioner/heater.
c.
Remove nut, washer, and screw from each corner of air conditioner/heater
mounting.
Remove screws securing mounting to section wall.
d. Disconnect drain line from air conditioner/heater.
e.
Attach sling to lifting handles.
Raise hoist enough to remove slack
from sling.
f. Remove mounting bolts and washers.
g.
Slide out air conditioner until other lifting handles
sling to handles.
h. Raise defective air conditioner/heater with hoist unt
from brackets and section.
i .
Place air conditioner/heater on flat-bed truck or pall
WARNING
are free.
Attach
il unit is free
e t .
Dry cleaning solvent, P-D-680, used to clean parts is potentially danger-
ous to personnel and property.
Avoid repeated and prolonged skin contact.
Wear solvent-impermeable gloves and eye/face protective equipment when
using solvent.
Do not use near open flame or excessive heat. Flash point
of solvent is 100° F to 138° F (38°C to 59° C).
j .
Clean sealant from opening using dry cleaning solvent P-D-680.
k. Remove damaged gasket and replace with new gasket.
l .
Raise air conditioner/heater until it rests on air conditioner/heater
brackets.
m.
Remove two sling hooks as unit is eased into hole until grille touches
duct .
n.
Remove remaining sling.
o.
Reinstall washers and mounting bolts.
p.
Reconnect
q.
Reinstall
wall. Rei
r .
Reinstall
s.
Reconnect
breaker.
drain lines.
screws securing air conditioner/heater mounting to section
nstall screw, washer, and nut to each corner of mounting.
screws securing air duct to air conditioner/heater.
or plug in power cord.
Turn on air conditioner/heater circuit
1-103
