TM 5-6675-324-14
R e m o v e springs, two bracket retaining screws and bracket at each end
i.
of reflector.
CAUTION
Do not touch exposure lamp with bare fingers. Fingerprints on glass will
cause premature failure of exposure lamp. If inadvertently touched, clean
it with cloth moistened with alcohol and then dry.
Remove defective exposure lamp from reflector.
j.
k. Clean reflector with cheesecloth moistened with denatured alcohol.
l.
Install new exposure lamp in reflector.
m.
Reinstall brackets and secure with screws.
Reinstall springs.
n.
o.
Reinstall exposure lamp and reflector assembly into frame.
Reconnect spring latches and secure with screws.
p.
Reconnect exposure lamp leads.
q.
eft to right.
r.
Reinstall copy belt by sliding it over rollers from
-
Center belt on rollers.
s.
Pull both latching levers forward and push them down
Rotate reflector locking lever down to locked position.
t.
Reinstall and close top cover.
u.
Plug in power cord.
v.
4-17. PREPARATION FOR STORAGE OR SHIPMENT. Contact your battalion for packing and
shipping instructions.
DIRECT/GENERAL SUPPORT MAINTENANCE
Section V
There are no direct/general support maintenance procedures assigned for this
equipment.
4-88
