TM 5-6675-324-14
Table 1-4. ORGANIZATIONAL TROUBLESHOOTING - Cont
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
4.
NO POWER TO EQUIPMENT - Cont
Check circuit breaker output for 120 V ac.
Step 3.
(a) If output voltage is present, proceed to step 4.
(b) If output voltage is not present, refer to direct/general
support maintenance for circuit breaker replacement
Remove receptacle and check for 120 V ac input.
Step 4.
(a) If present, replace receptacle (paragraph 1-16.6).
(b) If not present, refer to direct/general support maintenance
for repair or replacement of defective wiring.
1-16. MAINTENANCE PROCEDURES.
This section contains instructions covering organizational maintenance
functions for the Information Section. Personnel required are listed only if the
task requires more than one.
b. After completing each maintenance procedure, perform operational check to be
sure that equipment is properly functioning.
INDEX
PARAGRAPH
PROCEDURE
Replace Fluorescent Lamp Ballast . . . . . . . . . . . . . . . . . . . 1-16.1
Replace Radio Frequency (RF) Filter . . . . . . . . . . . . . . . . . . 1-16.2
Replace Fluorescent Lamp Switch . . . . . . . . . . . . . . . . . . . . 1-16.3
Replace On/Off Switch. . . . . . . . . . . . . . . . . . . . . . . . . 1-16.4
Replace Blackout/Dome Light Microswitch . . . . . . . . . . . . . . . . 1-16.5
1-61
