TM 5-6675-323-14
Table 9-5. TROUBLESHOOTING - Cont
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
14. CALCULATOR PRINTER WILL NOT ADVANCE - Cont
S t e p 4.
C h e c k to see if calculator PRGM/RUN switch is set to RUN.
(a) If PRGM/RUN is set properly, proceed to step 5.
(b) Set switch to RUN.
S t e p 5.
Run calculator diagnostic program on preprogrammed magnetic card.
Replace
calculator.
15.
CALCULATOR PRINTER ADVANCES, BUT NOTHING PRINTS WHEN
IS ACTIVATED.
S t e p 1.
Check to see if paper roll is jammed.
(a) If paper roll is free, proceed to step 2.
(b) Free paper roll.
S t e p 2.
Perform checks in malfunction 14.
16. AUTO-SCALER LED DISPLAY DOES NOT OPERATE OR SHOWS INCORRECT COUNT.
S t e p 1.
C h e c k to see if power source has 10 v dc to 15 V dc output.
(a) If output is correct, proceed to step 2.
(b) Change power source.
S t e p 2.
Check to see if voltage on regulator on main logic PC board is 8 V
dc .
(a) If voltage is correct, proceed to step 3.
(b) Notify direct/general support maintenance for replacement of
m a i n logic PC board.
9-133
