TM 5-6675-323-14
Table 3-20. PLOTTER PROGRAMMING LANGUAGE - Cont
S t a t e m e n t Identification and Use
Program
S t a t e m e n t , Syntax, Explanation, and Input Instructions
Statement
scl
- Cont
If scaling point P1 is assigned negative (-) coordinates and
P2 is assigned positive coordinates, origin is automatically
If both sets of coordinates for
set at center of plot area.
points are positive, origin will be off paper in lower left
For two negative sets of
corner as shown in illustration.
coordinates, origin is off paper in upper right corner.
S c a l e i s a u t o m a t i c a l l y s e t w h e n P l o t t e r i s i n i t i a l i z e d o r S Cl
statement without parameters is input. Origin is set at P1
and platen is divided into units 1 cm in length.
Coordinates of P1 and P2 in internal units of plotter are:
P 1 (520, 380) and P2 (15720, 10380)
3-184
