TM 5-6675-322-14
Section III OPERATOR MAINTENANCE
9-8. LUBRICATION INSTRUCTIONS.
This equipment does not require lubrication.
9 - 9 .
TROUBLESHOOTING PROCEDURES.
a .
The table lists the common malfunctions which you may find during operation
or maintenance of the support equipment.
You should perform the test/inspection and
c o r r e c t i v e a c t i o n s i n t h e o r d e r l i s t e d.
b . T h i s m a n u a l c a n n o t l i s t a l l m a l f u n c t i o n s t h a t m a y o c c u r , n o r a l l t e s t or
inspection and corrective actions.
I f a m a l f u n c t i o n i s n o t l i s t e d o r i s n ot
c o r r e c t e d b y l i s t e d c o r r e c t i v e a c t i o n s , n o t i f y y o u r s u p e r v i s o r .
Table 9-2. TROUBLESHOOTING
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
1.
MAGNIFIER LAMP ASSEMBLY WILL NOT LIGHT.
Check that magnifier lamp assembly is plugged into active power outlet.
Press switch OFF then ON.
(a) If lamp still does not come on, replace lamp (paragraph
9-10.1).
(b) If new lamp does not light, refer to organizational
maintenance.
2.
VACUUM CLEANER MOTOR DOES NOT OPERATE.
Step 1.
Check power cord.
( a ) I f p l u g g e d i n , p r o c e e d t o s t e p 2.
(b) Plug in power cord.
Step 2.
Check position of power switch.
(a) If turned on, proceed to step 3.
(b) Turn power switch on.
Step 3.
Check circuit breaker position in circuit breaker box.
( a ) I f t u r n e d o f f o r t r i p p e d , t u r n c i r c u i t b r e a k e r o n.
9-65
