TM 5-6675-322-14
Section III OPERATOR MAINTENANCE
8 - 8.
LUBRICATION INSTRUCTIONS.
This equipment does not require lubrication.
8 - 9.
TROUBLESHOOTING PROCEDURES.
There are no operator troubleshooting proce-
dures assigned for this equipment.
8-10.
MAINTENANCE PROCEDURES.
a. This section contains instructions covering operator maintenance functions
f o r t h e f u r n i t u r e a n d c a b i n e t s .
Personnel required are listed only if the task
requires more than one.
b. After completing each maintenance procedure, perform operational check to be
sure that equipment is properly functioning.
8 - 1 0 . 1 I n s p e c t F u r n i t u r e a n d C a b i n e t s .
I n s p e c t f u r n i t u r e a n d c a b i n e t s f o r
structural damage, rust, and proper operation of all latches, hinges, drawer slides,
and adjustment mechanisms.
Section IV ORGANIZATIONAL MAINTENANCE
8-11.
LUBRICATION INSTRUCTIONS.
This equipment does not require lubrication.
8-12.
REPAIR PARTS, SPECIAL TOOLS; TEST, MEASUREMENT, AND DIAGNOSTIC EQUIPMENT
(TMDE); AND SUPPORT EQUIPMENT.
8-12.1 Common Tools and Equipment.
For authorized common tools and equipment,
refer to the Modified Table of Organization and Equipment (MTOE) applicable to your
u n i t .
8-12.2 Special Tools: Test, Measurement, and Diagnostic Equipment: and Support
Equipment.
Special Tools, TMDE, and Support Equipment is listed in the applicable
repair parts and special tools list and in Appendix B of this manual .
8 - 1 2 . 3 R e p a i r P a r t s.
Repair parts are listed and illustrated in the Repair Parts
and Special Tools List, TM 5-6675-322-24P covering organizational maintenance for
this equipment.
8-13.
SERVICE UPON RECEIPT.
8-13.1 Checking Unpacked Equipment.
a. Inspect the equipment for damage incurred during shipment. If the equipment
has been damaged, report the damage on DD Form 6, Packing Improvement Report.
8-4
