TM 5-6675-322-14
4 - 6 .3
a.
b.
c.
d .
e.
f .
4 - 7 .
Preparation For Movement.
Place transport case on work surface.
Remove two attachment screws on each optical glass.
Place screws in transport case.
Pad optical glass and place in case.
Place stereometer in case.
C l o s e l i d
OPERATION
and check that lid latches.
UNDER UNUSUAL CONDITIONS.
The stereometer can be used under any
condition that permits use of a stereoscope .
S e c t i o n I II
OPERATOR MAINTENANCE
4 - 8.
LUBRICATION INSTRUCTIONS. This equipment does not require lubrication.
4-9. TROUBLESHOOTING.
There are no operator troubleshooting procedures assigned
for this equipment.
4-10 .
MAINTENANCE PROCEDURES.
There are no operator maintenance procedures
assigned for this equipment.
Section IV ORGANIZATIONAL MAINTENANCE
4-11.
LUBRICATION INSTRUCTIONS.
This equipment does not require lubrication.
4-12 .
REPAIR PARTS, SPECIAL TOOLS; TEST, MEASUREMENT, AND DIAGNOSTIC EQUIPMENT
(TMDE) ; AND SUPPORT EQUIPMENT.
These items are not required for this equipment .
4-13 .
SERVICE UPON RECEIPT.
4-13.1 Checking Unpacked Equipment.
a. Inspect the equipment for damage incurred during shipment. If equipment has
been damaged,
report the damage on DD Form 6, Packing Improvement Report.
b. Check the equipment against the packing list to see if the shipment is
complete.
Report all discrepancies in accordance with the instructions of DA Pam
738-750.
c .
Check to see whether the equipment has been modified.
4-15
