TM 5-6675-322-14
2 - 6 .
OPERATION UNDER USUAL CONDITIONS.
2-6.1 Assembly and Preparation for Use.
a.
Clean work surface.
b.
Plug power cord into electrical receptacle.
c .
Turn power switch on for light table use.
2-6.2 Operatinq Procedures,
a.
Changing Work Surface.
CAUTION
Safety stops have been included to prevent overtravel of table top and
d a m a g e t o e l e c t r i c a l w i r i n g.
I f d r a f t i n g s u r f a c e i s i n t o p p o s i t i o n ,
swing front edge of table top down to change work surface.
I f l i g h t
table is in top position, swing front edge up to change work surface.
Table cannot be rotated until cabinet assembly is swung out.
(1) Pull cabinet assembly lock release ring and swing out cabinet assembly.
( 2 ) L o o s e n t i l t l o c k u n t i l i t c l e a r s t a b l e t o p a s s e m b l y.
( 3 ) T i g h t e n t i l t l o c k t o s e c u r e t a b l e t o p a s s e m b l y i n p o s i t i o n.
(4) Return cabinet assembly to its normal position under table top assembly.
(5) Press firmly on cabinet assembly front until cabinet assembly lock
c l i c k s.
2-6.3 Preparation for Movement.
a.
Turn off power.
b . Unplug power cord.
Coil power cord and tape to table.
c .
Rotate table top assembly, if necessary, to be sure glass surface faces
upward.
d.
Tighten tilt lock to secure table top assembly.
e.
Press firmly on cabinet assembly front until cabinet assembly lock clicks.
f. Check cabinet drawers for open containers and loose items. Seal containers
and secure all loose items.
g .
Lock cabinet drawers.
2 - 7.
OPERATION UNDER UNUSUAL CONDITIONS.
This equipment is designed for
operation only in a controlled environment.
2-11
