TM 5-6675-321-14
Section IV ORGANIZATIONAL MAINTENANCE
1-11.
LUBRICATION INSTRUCTIONS.
This equipment does not require lubrication at
this level of maintenance.
1-12. REPAIR PARTS, SPECIAL TOOLS; TEST, MEASUREMENT, AND DIAGNOSTIC EQUIP-
MENT (TMDE); AND SUPPORT EQUIPMENT,
1-12.1 Common Tools and Equipment. For authorized
refer to the Modified Table of Organization and Equi
u n i t .
common tools and equipment,
pment (MTOE) applicable to your
1-12.2 Special Tools; Test, Measurement, and Diagnostic Equipment; and Support
Equipment.
Special Tools, TMDE, and Support Equipment is listed in the applicable
repair parts and special tools list and in Appendix B of this manual .
1 - 1 2 . 3 R e p a i r P a r t s.
Repair parts for this equipment are listed in the Repair
Parts and Special Tools List, TM 5-6675-321-24P covering organizational maintenance
for this equipment.
1-13. SERVICE UPON RECEIPT.
T h e s e ct
m o u n t i ng
c h a s s i s
NOTE
ion may be received mounted on a chassis or as a van body for
on an available transporter or on site.
Inspection of the
i s c o v e r e d i n T M 5 - 2 3 3 0 - 3 0 5 - 1 4 . I n s p e c t i o n o f t h e a ir
conditioner/heater is covered in TM 5-4120-367-14.
1-13.1 Checkinq Unpacked Equipment.
a.
Inspect the equipment for damage incurred durinq shipment.
If the equipment
has been damaged,
report the damage on DD Form 6, Packing Improvement Report.
( 1 ) V i s u a l l y i n s p e c t t h e s e c t i o n e x t e r i o r s t a r t i n g a t t h e r e a r t o c o v er
r e a r , c u r b s i d e , r o a d s i d e , f r o n t , t o p , a n d b o t t o m .
Inspect for damage, tears, breaks
o r c o r r o s i o n .
(2) Enter section and inspect for broken equipment, tool boxes, chairs, or
equipment loose and not secured.
(3) Close doors and vents to determine if light leaks exist.
(4) Inspect doors for damage, torn or rotted seals, and tightness of closure .
(5) Inspect interior for evidence of water damage, fungi, mildew or
c o r r o s i o n.
( 6 ) R e p o r t d a m a g e o r
11-2.
discrepancies in accordance with AR 735-11 and AR 735-
1-50
