TM 5-6675-321-14
Section Ill OPERATOR MAINTENANCE
1-8. LUBRICATION INSTRUCTIONS.
a.
Lubrication instructions for the Mosaicking/Drafting Section are contained
in LO 5-6675-321-12, Lubrication Order, Mosaicking/Drafting Section, Topographic
Support System.
The intervals and manhours specified in the Lubrication Order are
based on normal operations.
During inactive periods, lubrication periods may be
extended with adequate preservation.
b. Topographic equipment and all optical equipment require special care in
l u b r i c a t i o n .
When a specified lubricant is called for, substitutions are not au-
t h o r i z e d .
Minimum amounts of lubricant are to be used and all excess lubricant is
to be immediately removed.
Spray lubricants must not be used in the vicinity of
optical equipment unless optics are completely protected. No lubricant is to be
applied unless a thorough cleaning is conducted first to remove dirt, dust, or abra-
s i v e m a t e r i a l .
c .
Be sure that you refer to the appropriate chapter before any equipment is
stored after use, that the temperature has stabilized, and that required lubrication
after use is accomplished.
1-9. TROUBLESHOOTING PROCEDURES.
a .
The table lists the common malfunctions which you may find during operation
or maintenance of the Mosaicking/Drafting Section, or its components .
Y OU should
p e r f o r m t h e t e s t / i n s p e c t i o n s a n d c o r r e c t i v e a c t i o n s i n t h e o r d e r l i s t e d .
b . T h i s m a n u a l c a n n o t l i s t a l l m a l f u n c t i o n s t h a t m a y o c c u r , n o r a l l t e s t or
inspections and corrective actions .
I f a m a l f u n c t i o n i s n o t l i s t e d o r i s n ot
c o r r e c t e d b y l i s t e d c o r r e c t i v e a c t i o n s , n o t i f y y o u r s u p e r v i s o r .
1-42
