TM 5-6675-321-14
Section Ill OPERATOR MAINTENANCE
7-8. LUBRICATION INSTRUCTIONS.
This equipment does not require lubrication.
7-9. TROUBLESHOOTING PROCEDURES. There are no operator troubleshooting procedures
assigned for this equipment.
7-10. MAINTENANCE PROCEDURES.
a. This section contains instructions covering operator maintenance functions
f o r t h e f u r n i t u r e a n d c a b i n e t s . P e r s o n n e l r e q u i r e d a r e l i s t e d o n l y i f t h e t a sk
requires more than one.
b. After completing each maintenance procedure, perform operational check to be
sure that equipment is properly functioning.
7 - 1 0 . 1 I n s p e c t F u r n i t u r e a n d C a b i n e t s . I n s p e c t f u r n i t u r e a n d c a b i n e t s f or
structural damage, rust and proper operation of all latches, hinges, drawer slides
and adjustment mechanisms.
Section IV ORGANIZATIONAL MAINTENANCE
7-11. LUBRICATION INSTRUCTIONS. This equipment does not require lubrication.
7-12. REPAIR PARTS, SPECIAL TOOLS; TEST, MEASUREMENT, AND DIAGNOSTIC
EQUIPMENT (TMDE); AND SUPPORT EQUIPMENT.
7-12.1 Common Tools and Equipment. For authorized common tools and equipment,
refer to the Modified Table of Organization and Equipment (MTOE) applicable to your
u n i t .
7-12.2 Special Tools; Test. Measurement, and Diagnostic Equipment; and Support
Equipment.
Special Tools, TMDE, and Support Equipment is listed in the applicable
repair parts and special tools list and in Appendix B of this manual.
7 - 1 2 . 3 R e p a i r P a r t s . R e p a i r p a r t s a r e l i s t e d a n d i l l u s t r a t e d i n t h e R e p a i r P a r ts
and Special Tools List, TM 5-6675-321-24P covering organizational maintenance for
this equipment.
7-3
