TM 5-6675-321-14
i .
Remove cable wires from ground terminal, HEAT ON switch, and terminal
b l o c k.
j .
Pull cable out of wax coater through hole in rear panel.
k. Feed new cable through hole in rear panel and through cable holding
b r a c k e t s .
l .
Strip insulation from ends of wires and crimp on terminal connectors.
m.
Attach wires to ground, HEAT ON switch, and terminal block per wiring
schematic.
n .
Tighten cable holding brackets.
o.
R e i n s t a l l r i g h t s i d e p a n e l.
CAUTION
When moving inner panel,
keep rear of machine lifted so it does not catch on
p i l o t l i g h t o r d a m a g e t o l i g h t m a y r e s u l t .
4-20.10
p.
R e i n s t a l l i n n e r p a n e l .
q.
Reinstall top deck cover and top roller cover.
Replace Heating Element.
MOS: 83FJ6, Reproduction Equipment Repairer
TOOLS:
Flat Tip Screwdriver
Cross Tip Screwdriver
Wire Stripper/Crimper
Heat Shrink Gun
SUPPLIES:
Heating Element
WARNING
Serious injury may occur if internal components are touched when heat is
on.
Remove heat source and allow to cool, or wear protective clothing
b e f o r e s e r v i c i n g.
Death or serious injury may occur from electrical shock unless power
cord is unplugged before servicing.
a.
Unplug power cord.
b. Remove top deck cover and top roller cover.
4-76
