CAUTION
Removal of five socket head screws located
r e s u l t
c.
d.
TM 5-6675-321-14
closest to glass surface may
in damage to equipment.
Remove nine socket head screws and left panel, but do not remove five
socket head screws indicated in CAUTION and illustration.
Pull cabinet assembly lock release and swing cabinet assembly out so
t h a t i t i s n o t u n d e r t a b l e.
NOTE
Tilt lock plates are not interchangeable and must be replaced in same
p o s i t i o n s .
e.
Remove upper screws,
n u t s , a n d w a s h e r s f r o m d e f e c t i v e t i l t l o c k p l a t e.
f .
Tilt table top as necessary and remove defective tilt lock plate by
removing lower screws, nuts, and washers.
g.
Install new tilt lock plate and secure with washers, nuts, and screws.
h .
C h e c k p o s i t i o n o f t i l t l o c k p l a t e a n d r e a d j u s t i f r e q u i r e d.
i .
Remove defective limit control plate by removing screws, washers,
and nuts.
j .
I n s t a l l n e w l i m i t c o n t r o l p l a t e . S e c u r e w i t h n u t s , w a s h e r s , a nd
screws.
k.
Reinstall left panel and secure with nine socket head screws.
NOTE
Use care in disassembly of safety stop to prevent spring from falling inside
frame.
l .
Remove defective safety stop by removing nut, lockwasher, sleeve,
s pr in g , sp a ce r, a n d s c r e w.
m.
I n s t a l l n e w s a f e t y s t o p.
Secure with screw, spacer, spring, sleeve,
lockwasher, and nut.
n.
Swing cabinet assembly to its normal position under table.
o.
Plug in power cord.
2-31
