TM 5-6675-320-14
f.
g.
h.
i.
j.
k.
l.
m.
n.
o.
Tag wires from ballast for reference.
Disconnect ballast wire from wire nut connection.
Pry out lamp socket holder with flat tip screwdriver.
Using scribe, depress wire clips and disconnect ballast wiring.
Remove nut and defective ballast.
Install new ballast and connect wires to corresponding lamp socket holders.
Secure with nut.
Reconnect ballast wire to wire nut connection.
Remove tags.
Install new wire ties.
NOTE
Be sure wires are free of kinks do not interfere with placement of wire
guard.
p. Reinstall wire guard.
q. Reinstall lamp and safety tabs.
r.
Reinstall diffuser.
s. Turn on overhead light circuit breaker and main circuit breaker.
1-16.2 Replace Radio Frequency (RF) Filter.
MOS: 83FJ6, Reproduction Equipment Repairer
or
41B, Topographic Instrument Repair Specialist
TOOLS: Flat Tip Screwdriver
1/4 in. Combination Wrench
1/4 in. Drive Socket Set
SUPPLIES: RF Filter
Wire Ties
WARNING
Death or serious injury may occur unless overhead light switch is
turned OFF before working on light fixture.
1-62
Change 1
