TM 5-6675-320-14
Section III OPERATOR MAINTENANCE
1-8. LUBRICATION INSTRUCTIONS.
Lubrication instructions for the Rectifier II Section are contained in LO 5-
667-320-12, Lubrication Order, Rectifier II Section, Topographic Support System .
The intervals and man-hours specified in the Lubrication Order are based on normal
operations.
During inactive periods, lubrication periods may be extended with
adequate preservation.
b. Topographic equipment and all optical equipment require special care in
l u b r i c a t i o n .
When a specified lubricant is called for, substitutions are not au-
t h o r i z e d .
Minimum amounts of lubricant are to be used and all excess lubricant is
to be immediately removed.
Spray lubricants must not be used in the vicinity of
optical equipment unless optics are completely protected. No lubricant is to be
applied unless a thorough cleaning is conducted first to remove dirt, dust, or abra-
s i v e m a t e r i a l .
c .
Be sure that you refer to the appropriate chapter before any equipment is
stored after use, that the temperature has stabilized, and that lubrication required
after use is accomplished.
1-9. TROUBLESHOOTING PROCEDURES.
a.
The table lists the common malfunctions which you may find during operation
or maintenance of the Rectifier II Section, or its components.
You should perform
t h e t e s t / i n s p e c t i o n s a n d c o r r e c t i v e a c t i o n s i n t h e o r d e r l i s t e d .
b. This manual cannot list all malfunctions that may occur, nor all test or
inspections and corrective actions.
I f a m a l f u n c t i o n i s n o t l i s t e d o r i s n ot
c o r r e c t e d b y l i s t e d c o r r e c t i v e a c t i o n s , n o t i f y y o u r s u p e r v i s o r .
1-43
a.
