TM 5-6675-320-14f . P e n l i f t a d j u s t m e n t:(1) Using a 0-60 g gage, place the gage feeler on the solenoid platenear where the pen height adjustment screw touches the solenoidp l a t e .(2) The solenoid plate should start to move downward when a pressureof 51 ± 2 g is applied with the gage feeler.(3) To adjust, bend the bottom solenoid plate pen spring tab upward todecrease the pressure or downward to increase the pressure toobtain the correct gram pressure.g .Reinstall the pen cover.4-29.2 Pen Arm Adjustment (X-Drive).MOS:35E, Special Electronic Devices RepairerTOOLS: Flat Tip ScrewdriverCross Tip Screwdrivera.Remove rear hood from plotter.b. Load the plotter with lined chart paper and a new pen.c .Draw one line in the Y-axis on a chart grid line.d. Check this drawn line for any offset from the grid line.e .Set pen arm adjustment nut to correct any offset in perpendicularp l o t l i n e .f . R e i n s t a l l r e a r h o o d.4-255
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
