TM 5-6675-320-14
CHAPTER 1
RECTIFIER II SECTION
Section I INTRODUCTION
1-1 . GENERAL INFORMATION.
1-1.1 Scope .
This manual contains operating and maintenance instructions for the
ADC-TSS-09, Rectifier II Section, Topographic Support System (TSS). The purpose of
the Rectifier II Section is to provide ground coordinates, elevation, and dimensions
for aerial photographs. The trailer chassis is covered in TM 5-2330-305-14, Opera-
tor, Organizational, Direct Support and General Support Maintenance Manual, Topo-
graphic Support System, Chassis, Semitrailer, ISO Container Transporter. Repair
parts and special tools are listed in TM 5-6675-320-24P, Organizational, Direct
Support, and General Support Maintenance Repair Parts and Special Tools List, Recti-
fier II Section, Topographic Support System. Lubrication instructions are contained
in LO 5-6675-320-12, Lubrication Order, Rectifier II Section, Topographic Support
System. All authorized equipment, supplies, and their locations for transport are
shown in Location and Description of Major Components of this manual.
1-1.2 Purpose of Equipment.
T o p r o v i d e a t r a n s p o r t a b l e f a c i l i t y f o r e d i t i n g a nd
annotating photographic prints; providing ground coordinates, elevation, and
dimensions from aerial photographs; exercising quality control over Rectifier I; and
safeguarding topographic data.
1-1.3 Maintenance Forms and Records.
Department of the Army forms and procedure:
used for equipment maintenance will be those prescribed by DA Pam 738-750, The Army
Maintenance Management System (TAMMS).
1-1.4
Reporting
Equipment
Improvements
(EIR’s).
If
the
Rectifier
II
Section
needs
improvement, let us know. Send us an EIR. You, the user, are the only one who can
tell us what you do not like about your equipment. Let us know why you do not like
the design or performance. Put it on an SF 368 (Quality Deficiency Report). Mail
it to us at: U.S. Army Troop Support Command, ATTN: AMSTR-QX, 4300 Goodfellow Blvd.
St Louis, MO 63120-1798. We will send you a reply.
1-1.5 Destruction of Material to Prevent Enemy Use.
For information on destruction
of material to prevent enemy use, refer to TM 750-244-3, Procedures for Destruction
of Equipment to Prevent Enemy Use.
1-1.6 Preparation for Storage or Shipment.
a.
Perform your preparation for movement procedures.
b. For administrative storage of equipment, refer to TM 740-90-1.
c. The chapters of this manual describe special shipping instructions
for major components located in the section.
d. In the event this equipment must be removed from the section for repair or
replacement, contact your battalion for packing and shipping instructions.
Change 2 1-1
