TM 5-6675-319-14
Section IV ORGANIZATIONAL MAINTENANCE
11-11. LUBRICATION INSTRUCTIONS.
This equipment does not require lubrication .
11-12. REPAIR PARTS, SPECIAL TOOLS; TEST, MEASUREMENT, AND DIAGNOSTIC EQUIPMENT
(TMDE) ; AND SUPPORT EQUIPMENT.
11-12.1 Common Tools and Equipment.
For authorized common tools and equipment,
refer to the Modified Table of Organization and Equipment (MTOE) applicable to your
u n i t .
11-12.2 Special Tools : Test, Measurement. and Diagnostic Equipment; and Support
Equipment.
Special Tools, TMDE, and Support Equipment is listed in the applicable
repair parts and special tools list and in Appendix B of this manual .
11-12.3 Repair Parts.
Repair parts are listed and illustrated in the Repair Parts
and Special Tools List, TM 5-6675-319-24P covering organizational maintenance for
this equipment.
11-13. SERVICE UPON RECEIPT.
11-13.1 Checking Unpacked Equipment.
Inspect the equipment for damage incurred during shipment. If equipment has
been damaged, report the damage on DD Form 6, Packing Improvement Report.
b. Check the equipment against the packing list to see if the shipment is
complete.
Report all discrepancies in accordance with the instructions of DA Pam
738-750.
c .
Check to see whether the equipment has been modified.
11-14.
ORGANIZATIONAL PREVENTIVE MAINTENANCE CHECKS AND SERVICES. There are no
organizational PMCS procedures assigned for this equipment.
11-15. ORGANIZATIONAL TROUBLESHOOTING PROCEDURES.
Organizational troubleshooting procedures cover the most common malfunctions
that may be repaired at the organizational level.
Repair or adjustment requiring
specialized equipment is not authorized unless such equipment is available.
Troubleshooting procedures used by lower level maintenance should be conducted in
addition to the organizational troubleshooting procedures.
b. This manual cannot list all the possible malfunctions or every possible test/
inspection and corrective action .
If a malfunction is not listed or corrected by a
l i s t e d c o r r e c t i v e a c t i o n , n o t i f y y o u r s u p e r v i s o r.
c .
If any component of the support items does not power up when turned on,
verify that 120 V ac is present at the receptacle.
If voltage is not present, plug
equipment into receptacle with power available and proceed with equipment
t r o u b l e s h o o t i n g .
Perform no-power procedure for dead receptacle (Table 1-4).
11-19
a .
a .
