TM 5-6675-319-14
9-17.
PREPARATION FOR STORAGE OR SHIPMENT.
Contact your battalion for packing and
shipping instructions.
Section V DIRECT/GENERAL-SUPPORT MAINTENANCE
9-18.
REPAIR PARTS, SPECIAL TOOLS; TEST, MEASUREMENT, AND DIAGNOSTIC EQUIPMENT
(TMDE); AND SUPPORT EQUIPMENT.
9-18.1 Common Tools and Equipment. For
refer to the Modified Table of Organization
u n i t .
authorized common tools and equipment,
and Equipment (MTOE) applicable to your
9-18.2 Special Tools; Test, Measurement, and Diagnostic Equipment; and Support
Equipment.
Special tools; TMDE, and Support Equipment is listed in the applicable
repair parts and special tools list and in Appendix B of this manual.
9 - 1 8 . 3 R e p a i r P a r t s.
Repair parts are listed and illustrated in the Repair
Parts and Special Tools List, TM 5-6675-319-24P covering organizational maintenance
for this equipment.
9-19. DIRECT/GENERAL SUPPORT TROUBLESHOOTING PROCEDURES,
a.
Direct/general support troubleshooting procedures cover the most common
malfunctions that may be repaired at the direct/general support level. Repair or
adjustment requiring specialized equipment is not authorized unless such equipment
is available. Troubleshooting procedures used by lower level maintenance should be
conducted in addition to the direct/general support troubleshooting procedures.
b.
This manual cannot list all the possible malfunctions or every possible test/
inspection and corrective action.
I f a m a l f u n c t i o n i s n o t l i s t e d o r i s n o t c o r r e c t ed
by a listed corrective action, notify your supervisor.
For unidentified malfunctions, use the facing schematic or the foldout
located at the end of this manual for further fault analysis.
NOTE
S u f f i c i e n t d a t a i s n o t a v a i l a b l e f o r y o u t o t e s t o r t r o u b l e s h o o t p r i n t ed
c i r c u i t b o a r d s.
When associated wiring, ribbon cables, power cords and
other related electrical components have been eliminated as possible
faults, then the printed circuit boards must be substituted, one for one,
until the fault is isolated.
9-110
c .