TM 5-6675-319-14
CAUTION
To prevent damage to equipment or air shocks during transportation,
i n f l a t e a i r s h o c k s c o r r e c t l y.
Do not exceed 90 psi (620 kPa).
(2) Connect air hose to valve .
diaphragm is level as shown.
Death or serious injury may occur if power cable is disconnected while
power is on.
g.
Turn equipment switches off.
h.
Turn main circuit breaker off .
i .
Turn safety switch off.
j .
Have power cable
cable from receptacle .
k. Turn emergency li
l .
Disconnect teleph
disconnected at power supply end. Then disconnect power
Put cable in storage box on trailer chassis.
g h t s w i t c h o f f.
one cables from power entry panel.
CAUTION
To prevent loss of rod or thread damage, do not allow ground rod to
rotate and unscrew when removing the slide hammer rod.
m.
Remove ground rod with slide hammer, and put ground rods, couplings, and
slide hammer inside section.
Clean threads on each ground rod before storing.
1-37
(4) Reinstall valve caps.
(3) Inflate each mount until top of diagram is level as shown.
W A R N I N G
