TM 5-6675-319-14
Setscrew in
s e t s c r e w is
NOTE
spur gear hub has no function in this assembly. Be sure
not protruding from inner surface of gear.
k. Drive shear pin segments from gear and shaft.
NOTE
If spur gear is to be replaced, perform steps 1. and m. If not, proceed
to step n.
l .
Pull defective spur gear from motor drive shaft .
m.
Install new spur gear on drive shaft so that tapered holes in gear hub
and motor shaft are alined.
n .
Drive replacement shear pin into tapered holes.
o.
Move motor back to its mounted position and allow two spur gears to
engage.
NOTE
Before tightening mounting screws, check for proper alinement and meshing of
g e a r s.
7-130
