TM 5-6675-319-14
(1) Remove lamphouse block assemblies attached to both sides of cross shaft.
NOTE
R e c t i f i e r i s n o t n o r m a l l y s h i p p e d w i t h c u s h i o n i n g m a t e r i a l . U s e t h is
procedure only if cushioning material is installed .
(2) Disconnect lamphouse ground strap from lamphouse cover.
(3) Rotate cover clamp so that flat side of wahser is next to cover's edge.
(4) Raise lamphouse cover slightly.
(5) Remove cushioning material.
(6) Retighten cover clamps to hold lamphouse cover in place.
(7) Reinstall lamphouse ground strap.
7-65
