TM5-6675-319-14
CHAPTER 1
RECTIFIER I SECTION
Section I INTRODUCTION
1-1. GENERAL INFORMATION.
1-1.1 Scope. This manual contains operating and maintenance instructions for the ADC-TSS-08,
Rectifier I Section, Topographic Support System (TSS). The purpose of the Rectifier I Section is to produce
both rectified and unrectified prints and films. The trailer chassis is covered in TM 5-2330-305-14, Opera-
tor, Organizational, Direct Support and General Support Maintenance Manual, Topographic Support
System, Chassis, Semitrailer, ISO Container Transporter. Repair parts and special tools are listed in
TM 5-6675-319-24P, Organizational, Direct Support, and General Support Maintenance Repair Parts and
Special Tools List, Rectifier I Section, Topographic Support System. Lubrication instructions are contained
in LO 5-6675-319-12, Lubrication Order, Rectifier I Section, Topographic Support System. All authorized
equipment, supplies, and their locations for transport are shown in Location and Description of Major
Components of this manual.
1-1.2
Purpose of Equipment. To provide a transportable facility for producing rectified and unrectified
prints and films from roll or sheet film images and for processing exposed film for use in the TSS.
1-1.3 Maintenance Forms and Records.
Department of the Army forms and procedures used for equip-
ment maintenance will be those prescribed by DA Pam 738-750, the Army Maintenance Management
System (TAMMS).
1-1.4
Report Equipment Improvements (EIR's). If the Rectifier I Section needs improvement, let us
know. Send us an EIR. You, the user, are the only one who can tell us what you do not like about your
equipment. Let us know why you do not like the design or performance. Put it on an SF 368 (Quality
Deficiency Report). Mail it to us at: U.S. Army Troop Support Command, ATTN: AMSTR-MOF, 4300
Goodfellow Blvd., St. Louis, MO 63120. We will send you a reply.
1-1.5
Destruction of Material to Prevent Enemy Use. For information on destruction of material to pre-
vent enemy use, refer to TM 750-244-3, Procedures for Destruction of Equipment to Prevent Enemy Use.
1-1.6 Preparation for Storage or Shipment.
a. Perform your preparation for movement procedures.
b. For administrative storage of equipment, refer to TM 740-90-1.
c. The chapters of this manual describe special shipping instructions for major components located in
this section.
d. In the event this equipment must be removed from the section for repair or replacement, contact
your battalion for packing and shipping instructions.
Change 4 1-1
